[General] VoIP For Home Usage

[Majed B.]

It appears that's not a timing issue. It works only after I unplug and
replug the phone jack!! o_O;;;

I'll share my configs as soon as I fix this.

As for the zone info, I've set them to UK, but the driver still loads
in us mode :/
root at pbx:~ $ dmesg | grep -i fx
Port 1: Installed -- AUTO FXO (FCC mode)

I changed the parameters in /etc/dahdi/genconf_parameters:
lc_country              uk

That one sets the values of zones in system.conf when you run dahdi_genconf -Fv

I'll keep digging till I get it to load the proper zone and see if
UK's settings work.

On Fri, Aug 7, 2009 at 10:17 PM, Ahmad Al-Ibrahim<ahmad at koutbo6.com> wrote:
> Majed,
>
> What are the values you used for
> loadzone, defaultzone in /etc/dahdi/system.conf
> country in /etc/asterisk/indications.conf
>
> do you mind sharing chan-dahdi.conf and any other changed files?
>
> Regards,
>
> Ahmad Al-Ibrahim
>
> Majed B. wrote:
>> I can finally receive and make calls on the landline (PSTN)!
>>
>> I have no clue what made it work... Gonna take a backup of the current
>> configs and try to make it work again (and compare the config files to
>> a fresh installation).
>>
>> One post in a forum mentioned it was because asterisk was being
>> launched too soon...
>>
>> Ahmad,
>> Any progress on your end? Have you been able to work your card?
>>
>> On Fri, Aug 7, 2009 at 5:57 PM, Majed B.<majedb at gmail.com> wrote:
>>> Ahmad,
>>>
>>> If the card indicated a RED alarm when checking with the zap/dahdi
>>> tools, it means it's unable to detect the voltage on the line. That's
>>> when you try the cable trick.
>>>
>>> To check the alarm status:
>>> asterisk -rvvvvvvvvvv
>>> pbx*CLI> dahdi show status
>>> Description                                     Alarms  IRQ    bpviol
>>> CRC4   Fra Codi Options  LBO
>>> Wildcard TDM410P Board 1                 OK      1      0      0
>>> CAS Unk  YEL      0 db (CSU)/0-133 feet (DSX-1)
>>>
>>> If you have zaptel, then type: zap show status
>>>
>>> I hope that makes it clearer a bit.
>>>
>>> As on my end, I was able to define the channels (FINALLY) for asterisk
>>> with dahdi! Seems like all I had to do is include dahdi-channels.conf
>>> into chan_dahdi.conf
>>>
>>> I can receive calls now, but I can't make any out, yet.
>
> _______________________________________________
> General mailing list
> General at oskw.org
> http://oskw.org/mailman/listinfo/general_oskw.org
>



-- 
       Majed B.