[General] VoIP For Home Usage

[Ahmad Al-Ibrahim]

Majed,

What are the values you used for
loadzone, defaultzone in /etc/dahdi/system.conf
country in /etc/asterisk/indications.conf

do you mind sharing chan-dahdi.conf and any other changed files?

Regards,

Ahmad Al-Ibrahim

Majed B. wrote:
> I can finally receive and make calls on the landline (PSTN)!
> 
> I have no clue what made it work... Gonna take a backup of the current
> configs and try to make it work again (and compare the config files to
> a fresh installation).
> 
> One post in a forum mentioned it was because asterisk was being
> launched too soon...
> 
> Ahmad,
> Any progress on your end? Have you been able to work your card?
> 
> On Fri, Aug 7, 2009 at 5:57 PM, Majed B.<majedb at gmail.com> wrote:
>> Ahmad,
>>
>> If the card indicated a RED alarm when checking with the zap/dahdi
>> tools, it means it's unable to detect the voltage on the line. That's
>> when you try the cable trick.
>>
>> To check the alarm status:
>> asterisk -rvvvvvvvvvv
>> pbx*CLI> dahdi show status
>> Description                                     Alarms  IRQ    bpviol
>> CRC4   Fra Codi Options  LBO
>> Wildcard TDM410P Board 1                 OK      1      0      0
>> CAS Unk  YEL      0 db (CSU)/0-133 feet (DSX-1)
>>
>> If you have zaptel, then type: zap show status
>>
>> I hope that makes it clearer a bit.
>>
>> As on my end, I was able to define the channels (FINALLY) for asterisk
>> with dahdi! Seems like all I had to do is include dahdi-channels.conf
>> into chan_dahdi.conf
>>
>> I can receive calls now, but I can't make any out, yet.