[General] VoIP For Home Usage

[Majed B.]

@@ !!

What if all the sockets have 2 wires only?!?!

On Thu, Aug 6, 2009 at 9:30 PM, Faisal AlAbhoul<kuwait at q8net.com> wrote:
> Oh you using Asterisk 1.6? the Ring/Disconnect tones should not change,
> thats strange. I'll send you the "kw" tone settings soon.
>
> Did you try using 4-wires RJ11 socket instead of 2-wires? provided the
> socket on the wall also 4-wires. i dont know why but it i remember that
> helped with my TDM400P.
>
>
>
> --- On Thu, 6/8/09, Ahmad Al-Ibrahim <ahmad at koutbo6.com> wrote:
>
> From: Ahmad Al-Ibrahim <ahmad at koutbo6.com>
> Subject: Re: [General] VoIP For Home Usage
> To: "General OpenSource Discussion" <general at oskw.org>
> Date: Thursday, 6 August, 2009, 9:23 PM
>
> Thanks Bo Rashed,
>
> I've tried that without luck, I think I'm going to re-install.
>
> Dahdi is still Starting/Hanging up every second.
>
> Regards,
>
> Ahmad Al-Ibrahim
>
> Faisal AlAbhoul wrote:
>> Set the tone to Germany, it matches Kuwait perfectly.
>>
>>
>> --- On *Tue, 4/8/09, Ahmad Al-Ibrahim /<ahmad at koutbo6.com>/* wrote:
>>
>>
>>     From: Ahmad Al-Ibrahim <ahmad at koutbo6.com>
>>     Subject: Re: [General] VoIP For Home Usage
>>     To: "General OpenSource Discussion" <general at oskw.org>
>>     Date: Tuesday, 4 August, 2009, 4:16 AM
>>
>>     I have configured the trunks, inbound routes, zap channels. It seems
>> to
>>     be something related to the line it self or the configurations to
>> match
>>     Kuwait PSTN tones, are you able to call the land line? and do you see
>>     debug information on asterisk CLI while calling the land line? What is
>>     the 'country' variable value in indications.conf, 'loadzone' and
>>     'defaultzone' variables values in zaptel.conf?
>>
>>     Having a cronjob wont harm your system, atleast it works.
>>
>>     I've already saw this link in the morning, I dont have acpi variable
>> set
>>     in grub.conf.
>>
>>     Regards,
>>
>>     Ahmad Al-Ibrahim
>>
>>     Majed B. wrote:
>>     > I was just about to email and ask you how things are going on your
>>     end! hahaha.
>>     >
>>     > Well, seems like I wasn't the only one going through trouble...
>>     >
>>     > Have you configured the trunk, made sure the Outbound route is using
>>     > that trunk, and that you have configured a general Inbound route?
>> Did
>>     > you configure an extension to receive/make calls?
>>     >
>>     > I know it sounds silly, but go over them again and try recreating
>> the
>>     > extension or make a new one and divert the inbound calls to it.
>>     >
>>     > I'll look around and see what could cause your problems.
>>     >
>>     > As for my side, remember that NAT & externip thing? It worked for a
>>     > while, when asterisk wanted it to, then it broke. If in the home
>> page
>>     > the value "Public IP" is "Unknown" then you can kiss your audio good
>>     > bye on any device outside the LAN from receiving audio. I'm too
>> close
>>     > to stab someone in the face... it's quite frustrating because my
>>     > settings should work, and I don't want to run a script with a cron
>> job
>>     > to replace the domain name with the IP :/
>>     >
>>     > On Tue, Aug 4, 2009 at 3:10 AM, Ahmad Al-Ibrahim<ahmad at koutbo6.com
>>     </mc/compose?to=ahmad at koutbo6.com>> wrote:
>>     >> Majed,
>>     >>
>>     >> I've installed OpenVox card, ran setup-pstn, the card was
>>     detected and
>>     >> configured, but I'm having problems, not sure what else needs to
>>     be done.
>>     >>
>>     >> I keep getting lots of
>>     >>
>>     >>    -- Hungup 'DAHDI/1-1'
>>     >>    -- Starting simple switch on 'DAHDI/1-1'
>>     >>    -- Hungup 'DAHDI/1-1'
>>     >>    -- Starting simple switch on 'DAHDI/1-1'
>>     >>    -- Hungup 'DAHDI/1-1'
>>     >>    -- Starting simple switch on 'DAHDI/1-1'
>>     >>
>>     >>
>>     >> messages in asterisk console when the line is connected behind an
>>     ADSL
>>     >> splitter, and when i call the land line number the phone rings,
>>     pick up
>>     >> and hangups every second simultaneously with the messages above.
>> I've
>>     >> removed the ADSL splitter and connected the line directly to the
>>     box, I
>>     >> keep getting busy tone.
>>     >>
>>     >> Do I have to configure the device specifically for Kuwait PSTN
>> tones?
>>     >>
>>     >> BTW Dahdi is zaptel in Asterisk 1.6
>>     >>
>>     >> Regards,
>>     >>
>>     >> Ahmad Al-Ibrahim
>>
>>     _______________________________________________
>>     General mailing list
>>     General at oskw.org </mc/compose?to=General at oskw.org>
>>     http://oskw.org/mailman/listinfo/general_oskw.org
>>
>>
>> ------------------------------------------------------------------------
>>
>> _______________________________________________
>> General mailing list
>> General at oskw.org
>> http://oskw.org/mailman/listinfo/general_oskw.org
>
> _______________________________________________
> General mailing list
> General at oskw.org
> http://oskw.org/mailman/listinfo/general_oskw.org
>
> _______________________________________________
> General mailing list
> General at oskw.org
> http://oskw.org/mailman/listinfo/general_oskw.org
>
>



-- 
       Majed B.