[General] VoIP For Home Usage
Ahmad Al-Ibrahim
ahmad at koutbo6.com
Thu Aug 6 22:28:38 +03 2009
Interesting, I checked the wall socket, there are 2 gray wires each of
them having 4 colored wires, and only 2 colored wires of each gray wires
are connected to the socket (2 red wires to the right, 2 blue wires to
the left) 4 other wires are not connected. 2 in each gray wires. I'm not
familiar with wiring. Now do I have to connect the others? IIRC the
others are not used/utilized.
Regards,
Ahmad Al-Ibrahim
Faisal AlAbhoul wrote:
> Easy, just change the wall socket, you can join 4-wires together in the
> wall socket itself to be powered by the line voltage itself. Dont try it
> unless you update the "kw" settings which Majed thankfully saved me from
> searching. Was going to get the settings from my Trixbox but
> unfortunately i cant SSH into my Trixbox, its a blackbox in my home
> network and heavily jailed.
>
>
> --- On *Thu, 6/8/09, Majed B. /<majedb at gmail.com>/* wrote:
>
>
> From: Majed B. <majedb at gmail.com>
> Subject: Re: [General] VoIP For Home Usage
> To: "General OpenSource Discussion" <general at oskw.org>
> Date: Thursday, 6 August, 2009, 9:32 PM
>
> @@ !!
>
> What if all the sockets have 2 wires only?!?!
>
> On Thu, Aug 6, 2009 at 9:30 PM, Faisal AlAbhoul<kuwait at q8net.com
> </mc/compose?to=kuwait at q8net.com>> wrote:
> > Oh you using Asterisk 1.6? the Ring/Disconnect tones should not
> change,
> > thats strange. I'll send you the "kw" tone settings soon.
> >
> > Did you try using 4-wires RJ11 socket instead of 2-wires? provided the
> > socket on the wall also 4-wires. i dont know why but it i remember
> that
> > helped with my TDM400P.
> >
> >
> >
> > --- On Thu, 6/8/09, Ahmad Al-Ibrahim <ahmad at koutbo6.com
> </mc/compose?to=ahmad at koutbo6.com>> wrote:
> >
> > From: Ahmad Al-Ibrahim <ahmad at koutbo6.com
> </mc/compose?to=ahmad at koutbo6.com>>
> > Subject: Re: [General] VoIP For Home Usage
> > To: "General OpenSource Discussion" <general at oskw.org
> </mc/compose?to=general at oskw.org>>
> > Date: Thursday, 6 August, 2009, 9:23 PM
> >
> > Thanks Bo Rashed,
> >
> > I've tried that without luck, I think I'm going to re-install.
> >
> > Dahdi is still Starting/Hanging up every second.
> >
> > Regards,
> >
> > Ahmad Al-Ibrahim
> >
> > Faisal AlAbhoul wrote:
> >> Set the tone to Germany, it matches Kuwait perfectly.
> >>
> >>
> >> --- On *Tue, 4/8/09, Ahmad Al-Ibrahim /<ahmad at koutbo6.com
> </mc/compose?to=ahmad at koutbo6.com>>/* wrote:
> >>
> >>
> >> From: Ahmad Al-Ibrahim <ahmad at koutbo6.com
> </mc/compose?to=ahmad at koutbo6.com>>
> >> Subject: Re: [General] VoIP For Home Usage
> >> To: "General OpenSource Discussion" <general at oskw.org
> </mc/compose?to=general at oskw.org>>
> >> Date: Tuesday, 4 August, 2009, 4:16 AM
> >>
> >> I have configured the trunks, inbound routes, zap channels.
> It seems
> >> to
> >> be something related to the line it self or the configurations to
> >> match
> >> Kuwait PSTN tones, are you able to call the land line? and do
> you see
> >> debug information on asterisk CLI while calling the land
> line? What is
> >> the 'country' variable value in indications.conf, 'loadzone' and
> >> 'defaultzone' variables values in zaptel.conf?
> >>
> >> Having a cronjob wont harm your system, atleast it works.
> >>
> >> I've already saw this link in the morning, I dont have acpi
> variable
> >> set
> >> in grub.conf.
> >>
> >> Regards,
> >>
> >> Ahmad Al-Ibrahim
> >>
> >> Majed B. wrote:
> >> > I was just about to email and ask you how things are going
> on your
> >> end! hahaha.
> >> >
> >> > Well, seems like I wasn't the only one going through trouble...
> >> >
> >> > Have you configured the trunk, made sure the Outbound route
> is using
> >> > that trunk, and that you have configured a general Inbound
> route?
> >> Did
> >> > you configure an extension to receive/make calls?
> >> >
> >> > I know it sounds silly, but go over them again and try
> recreating
> >> the
> >> > extension or make a new one and divert the inbound calls to it.
> >> >
> >> > I'll look around and see what could cause your problems.
> >> >
> >> > As for my side, remember that NAT & externip thing? It
> worked for a
> >> > while, when asterisk wanted it to, then it broke. If in the
> home
> >> page
> >> > the value "Public IP" is "Unknown" then you can kiss your
> audio good
> >> > bye on any device outside the LAN from receiving audio. I'm too
> >> close
> >> > to stab someone in the face... it's quite frustrating
> because my
> >> > settings should work, and I don't want to run a script with
> a cron
> >> job
> >> > to replace the domain name with the IP :/
> >> >
> >> > On Tue, Aug 4, 2009 at 3:10 AM, Ahmad
> Al-Ibrahim<ahmad at koutbo6.com </mc/compose?to=ahmad at koutbo6.com>
> >> </mc/compose?to=ahmad at koutbo6.com
> </mc/compose?to=ahmad at koutbo6.com>>> wrote:
> >> >> Majed,
> >> >>
> >> >> I've installed OpenVox card, ran setup-pstn, the card was
> >> detected and
> >> >> configured, but I'm having problems, not sure what else
> needs to
> >> be done.
> >> >>
> >> >> I keep getting lots of
> >> >>
> >> >> -- Hungup 'DAHDI/1-1'
> >> >> -- Starting simple switch on 'DAHDI/1-1'
> >> >> -- Hungup 'DAHDI/1-1'
> >> >> -- Starting simple switch on 'DAHDI/1-1'
> >> >> -- Hungup 'DAHDI/1-1'
> >> >> -- Starting simple switch on 'DAHDI/1-1'
> >> >>
> >> >>
> >> >> messages in asterisk console when the line is connected
> behind an
> >> ADSL
> >> >> splitter, and when i call the land line number the phone
> rings,
> >> pick up
> >> >> and hangups every second simultaneously with the messages
> above.
> >> I've
> >> >> removed the ADSL splitter and connected the line directly
> to the
> >> box, I
> >> >> keep getting busy tone.
> >> >>
> >> >> Do I have to configure the device specifically for Kuwait PSTN
> >> tones?
> >> >>
> >> >> BTW Dahdi is zaptel in Asterisk 1.6
> >> >>
> >> >> Regards,
> >> >>
> >> >> Ahmad Al-Ibrahim
> >>
> >> _______________________________________________
> >> General mailing list
> >> General at oskw.org </mc/compose?to=General at oskw.org>
> </mc/compose?to=General at oskw.org </mc/compose?to=General at oskw.org>>
> >> http://oskw.org/mailman/listinfo/general_oskw.org
> >>
> >>
> >>
> ------------------------------------------------------------------------
> >>
> >> _______________________________________________
> >> General mailing list
> >> General at oskw.org </mc/compose?to=General at oskw.org>
> >> http://oskw..org/mailman/listinfo/general_oskw.org
> <http://oskw.org/mailman/listinfo/general_oskw.org>
> >
> > _______________________________________________
> > General mailing list
> > General at oskw.org </mc/compose?to=General at oskw.org>
> > http://oskw.org/mailman/listinfo/general_oskw.org
> >
> > _______________________________________________
> > General mailing list
> > General at oskw.org </mc/compose?to=General at oskw.org>
> > http://oskw.org/mailman/listinfo/general_oskw.org
> >
> >
>
>
>
> --
> Majed B..
>
> _______________________________________________
> General mailing list
> General at oskw.org </mc/compose?to=General at oskw.org>
> http://oskw.org/mailman/listinfo/general_oskw.org
>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> General mailing list
> General at oskw.org
> http://oskw.org/mailman/listinfo/general_oskw.org
More information about the General
mailing list