[General] VoIP For Home Usage
Majed B.
majedb at gmail.com
Tue Aug 4 03:28:57 +03 2009
Ahmad,
I think this may help you:
http://www.trixbox.org/forums/trixbox-forums/help/tb-28-asterisk-16-tdm400
Let me know how things go.
On Tue, Aug 4, 2009 at 3:21 AM, Majed B.<majedb at gmail.com> wrote:
> I was just about to email and ask you how things are going on your end! hahaha.
>
> Well, seems like I wasn't the only one going through trouble...
>
> Have you configured the trunk, made sure the Outbound route is using
> that trunk, and that you have configured a general Inbound route? Did
> you configure an extension to receive/make calls?
>
> I know it sounds silly, but go over them again and try recreating the
> extension or make a new one and divert the inbound calls to it.
>
> I'll look around and see what could cause your problems.
>
> As for my side, remember that NAT & externip thing? It worked for a
> while, when asterisk wanted it to, then it broke. If in the home page
> the value "Public IP" is "Unknown" then you can kiss your audio good
> bye on any device outside the LAN from receiving audio. I'm too close
> to stab someone in the face... it's quite frustrating because my
> settings should work, and I don't want to run a script with a cron job
> to replace the domain name with the IP :/
>
> On Tue, Aug 4, 2009 at 3:10 AM, Ahmad Al-Ibrahim<ahmad at koutbo6.com> wrote:
>> Majed,
>>
>> I've installed OpenVox card, ran setup-pstn, the card was detected and
>> configured, but I'm having problems, not sure what else needs to be done.
>>
>> I keep getting lots of
>>
>> -- Hungup 'DAHDI/1-1'
>> -- Starting simple switch on 'DAHDI/1-1'
>> -- Hungup 'DAHDI/1-1'
>> -- Starting simple switch on 'DAHDI/1-1'
>> -- Hungup 'DAHDI/1-1'
>> -- Starting simple switch on 'DAHDI/1-1'
>>
>>
>> messages in asterisk console when the line is connected behind an ADSL
>> splitter, and when i call the land line number the phone rings, pick up
>> and hangups every second simultaneously with the messages above. I've
>> removed the ADSL splitter and connected the line directly to the box, I
>> keep getting busy tone.
>>
>> Do I have to configure the device specifically for Kuwait PSTN tones?
>>
>> BTW Dahdi is zaptel in Asterisk 1.6
>>
>> Regards,
>>
>> Ahmad Al-Ibrahim
> --
> Majed B.
>
--
Majed B.
More information about the General
mailing list